Real-world Industry 4.0. Where to start?

In this article we looked at an overview of Industry 4.0, the fourth evolution in manufacturing.  We discussed what it is and the impacts it can have. In essence, Industry 4.0 is about the capture, distribution and sharing of data … Continue reading

Categories News

Real world growth of integrated process data comms

Denca installed its very first Business Energy Management System in 2014. Since then, we have seen an increase in both interest and project commitments from our customers. This trend looks set to continue as more and more manufacturers recognise the … Continue reading

Categories News

Industry 4.0 – Dawn of a new era?

Industry 4.0 is the fourth era of manufacturing. The First Era Started in the 17th & early 18th centuries with the first mechanical machinery that carried out work previously people did manually, leading to the Industrial Revolution. The Second Era followed … Continue reading

Categories News, Technical Information

Handling the Brain-Drain – the Denca way

Shifting Roles It’s not just Denca’s customers that face the issues presented by the loss of in-house technical capability and competencies. Consequently, Denca itself has to address and respond to the very same challenges. In some ways, the reduction in … Continue reading

Categories News, Denca Development

Delivering capability from Denca

In this article, we looked at delivering capability and the major shift in the approach of many process companies to performing maintenance and upgrades of electrical process control systems at their plants.  Today, many manufacturers do not have enough electrical … Continue reading

Categories News

A changing world of in-house technical capability

Until relatively recently, most sophisticated manufacturing companies employed their own, sometimes extensive, in-house technical capability for electrical controls engineering. However, with the drive towards lean manufacturing from the mid-1980’s to the mid-noughties, this all changed. Companies both trimmed their own … Continue reading

Categories News

Safe Installation in ATEX-certified combustible dust zone

Our Client Our client is a specialist manufacturer of pigments. Consequently, managing dust and fine powders is a day-to-day requirement. The Issue A mixer was installed on-site in an area that had been designated a combustible dust risk zone under ATEX/DSEAR regulations. A … Continue reading

Categories Software, News, Case Study, Design, Documentation, ATEX, Installation

Operating in Combustible Dust Environments

As demonstrated in the case of the Bosley Mill Explosion in 2015, combustible dust can present a significant danger in processing environments. Up until quite recently, ignorance of these risks had led to a degree of complacency across many manufacturing sectors. … Continue reading

Categories Technical Information, Services, ATEX, Denca Development, News

Annual Customer Survey 2018 – The Results

Thank you to everyone who took part in our 2018 Customer Survey. Your feedback means a lot to us. It allows us to improve and deliver an even better service in the future. We will always listen and respond quickly … Continue reading

Categories News, Denca Development

The explosive dangers of dust and powders

In July 2015 an explosion at a wood mill is Bosley near Macclesfield killed 4 people.  In subsequent investigations, the Health and Safety Executive implicated ‘Dust Issues’ as the cause of the explosion. The danger of explosive dust and fine powders … Continue reading

Categories Pharma, Chemical, News, ATEX, Food-Bev